Loading... Please wait...

How to Install the Metal Parking Stand

Posted

How to Install the Metal Parking Stand

Parts that you will receive:

  • one (1) large rubber washer
  • one (1) large metal washer
  • one (1) small washer
  • one (1) small lock washer
  • two (2) Philips head machine screws, one short and one slightly longer (short screw is missing from this image)
  • four (4) large set screws
  • one (1) multi-purpose tool
  • one (1) axel
  • two (2) pedestals
  • one (1) mounting bracket




    Slide the axel through the opening in the bottom of the mounting bracket.  Center to the best of your ability and mark the axel along the outer edges of the mounting bracket.




    Attach one of the pedestals to the axel using your mark as a guide.




    Attach one of the pedestals to the axel using your mark as a guide.  Using the multi-purpose tool secure with two (2) set screws.




    Slide the axel through the opening at the bottom of the mounting bracket and attach the remaining pedestal to the axel.  Secure with two (2) set screws.




    You should have the following items remaining, plus a short machine screw (short machine screw not shown in this image).




    Place a small lock washer on the short machine screw followed by the small metal washer.  Insert into the mounting bracket as shown below.




    Use a Phillips head screw driver to help you guide the short machine screw to the hole directly below the power button.  Loosely attach the mounting bracket (a couple of screwdriver turns).




    You need the bracket to be loose so you are able to slightly pull it back and away from the Ninebot.   




    Place a small lock washer on the longer machine screw followed by a small metal washer. 




    Insert into the mounting bracket as shown below.




    Pick up the large metal washer, and larger rubber washer and arrange as shown below.




    Place large washers on machine screw as shown below.




    Use a Phillips head screw driver to help you guide the short machine screw to the hole on the Ninebot One.




    Hand tighten each of the machine screws to secure the mounting bracket.

    Congratulations!  You have installed the Metal Parking Stand!